一、预埋件设计标高、位置、数量须符合设计及安装要求，并经防腐防锈处理。埋件不符合要求时，应及时采取有效措施，增补埋件。这一点特别重要，大家也都知道预埋铁应该最开始就要做好的工序。

1、 The design elevation, position, and quantity of embedded parts must meet the design and installation requirements, and undergo anti-corrosion and rust prevention treatment. When the embedded parts do not meet the requirements, effective measures should be taken in a timely manner to supplement the embedded parts. This is particularly important, as we all know that pre embedding iron should be done from the beginning.

二、安装铁艺护栏立杆的部位时，基层混凝土不得有酥松现象，并且安装标高应符合设计要求，凹凸不平处必须剔除或修补平整，过凹处及基层蜂窝麻面严重处，不得用水泥砂浆修补，应用高强混凝土进行修补，并待有一定强度后，方可进行铁艺护栏的安装。

2、 When installing the upright pole of the wrought iron guardrail, the base concrete should not have any looseness, and the installation elevation should meet the design requirements. Uneven and uneven areas must be removed or repaired flat. Over concave areas and areas with severe honeycomb and rough surfaces on the base should not be repaired with cement mortar. High strength concrete should be used for repair, and the installation of the wrought iron guardrail can only be carried out after a certain strength is achieved.

诚信不锈钢铁艺加工厂再次提醒您：一定要按规程安装，才能保证我们的安全，不合格的安装铁艺护栏，会存在很多隐患，大家一定要防止。因为生命才是最重要的。

Integrity Stainless Steel and Iron Processing Factory reminds you once again: it is necessary to install according to regulations to ensure our safety. Installing iron guardrails that are not qualified will pose many hidden dangers, and everyone must prevent them. Because life is the most important thing.

下面我给大家总结以下铁艺护栏安装时所需要注意的几点具体细节要求：

Below, I will summarize the specific details that need to be paid attention to when installing wrought iron guardrails:

一、铁艺护栏到达施工现场后按图纸上所规定的位置及尺寸准确安装就位，确定好标高及垂直平整度。应按照甲方要求与图纸设计要求进行定位，确保达到设计要求与验收规范。

1、 After arriving at the construction site, the wrought iron guardrail shall be accurately installed in place according to the position and size specified on the drawings, and the elevation and vertical flatness shall be determined. The positioning should be carried out according to the requirements of Party A and the design requirements of the drawings to ensure that the design requirements and acceptance specifications are met.

二、预埋件安装根据图纸设计要求和施工现场的实际情况准确无误的定位，避免造成不在一条平行线上。

2、 The installation of embedded parts should be accurately and precisely positioned according to the design requirements of the drawings and the actual situation of the construction site, to avoid not being on a parallel line.

三、铁艺护栏所提供的标准线抄水平定位安装，预埋间距根据楼梯踏步数量及图纸设计要求，安装定位。

3、 The standard line provided by the wrought iron guardrail is horizontally positioned for installation, and the embedded spacing is determined based on the number of stair steps and the design requirements of the drawings.

四、安装偏差必须符合国家规定和设计要求，达到验收标准。

4、 The installation deviation must comply with national regulations and design requirements, and meet the acceptance standards.

五、预埋件、铁艺栏杆安装必须牢固，安装偏差根据国家规定和设计要求：扶手直线度<3mm，垂直度<3mm，栏杆间距误差<3mm，对角线误差<3mm，预埋件垂直误差<3mm，水平误差<3mm。

5、 The installation of embedded parts and wrought iron railings must be firm, and the installation deviation should comply with national regulations and design requirements: the straightness of the handrail should be less than 3mm, the verticality should be less than 3mm, the spacing error between railings should be less than 3mm, the diagonal error should be less than 3mm, the vertical error of embedded parts should be less than 3mm, and the horizontal error should be less than 3mm.

六、预埋件安装定位准确无误经验收后刷两道防锈漆，再进行铁艺护栏安装。

6、 After the installation and positioning of the embedded parts are accurate and verified, two coats of anti rust paint will be applied before installing the wrought iron guardrail.

七、铁艺护栏安装完成后，接部位打磨光滑，刷两道防锈漆，经验收后再做表面一致处理。

7、 After the installation of the wrought iron guardrail is completed, the joint should be polished smooth and coated with two layers of anti rust paint. After acceptance, the surface should be treated uniformly.

八、铁艺护栏安装运输过程中，为防止阳台栏杆的擦伤损坏，应做包装防护。

8、 During the installation and transportation of wrought iron guardrails, packaging protection should be provided to prevent scratches and damage to balcony railings.