铁艺大门工艺制作流程

The production process of iron gate technology

　　1.铁艺大门头焊接 依次将各头分别焊在相应的位置上.要求与横杆垂直,正面朝前,不能扭曲。 2.铁艺大门短横管焊接 每扇铁艺大门24根.按图样中的位置摆好。先点焊,再校平,检查无误后再焊牢。为防止焊接变形,可问隔焊。由于顺序打乱,焊点较多,焊完后应检查有无漏焊部位。

1. The welding of the iron gate head should be carried out sequentially, with each head welded to its corresponding position. It is required to be perpendicular to the crossbar, facing forward, and not twisted. 2. Weld 24 short horizontal pipes for each iron gate. Arrange them according to the position in the drawing. First spot weld, then level, check for accuracy, and then weld firmly. To prevent welding deformation, shielded welding can be used. Due to the disordered sequence and a large number of welding points, it is necessary to check for any missed welding areas after welding.

　　3.铁艺大门花形焊接 把所有花形分别摆放在相应位置上,看是否合适,调整无误后,先点焊到框架上,整体再检查一遍,然后焊牢。

3. Iron gate flower welding: Place all flower shapes in their respective positions to see if they are suitable. After adjusting them correctly, spot weld them onto the frame first, inspect the overall structure again, and then weld them firmly.

　　4.铁艺大门中间短竖管焊接 侮扇铁艺大门4根.按图样中的位置摆好。先点焊,再校平,检查无误后再焊牢。

4. Four short vertical pipes are welded to the middle of the iron gate, and the iron gate is positioned according to the drawing. First spot weld, then level, check for accuracy, and then weld firmly.

　　5.铁艺大门中间长竖管焊接 每扇铁艺大门3根长竖管,均匀分布在边框内,间距为339毫米。

5. The middle long vertical pipe of the iron gate is welded with 3 long vertical pipes for each iron gate, evenly distributed within the frame, with a spacing of 339 millimeters.

以上就是有关：济南铁艺大门  的介绍，想了解更多的内容请点击：http://www.jnghbxg.com 我们将会全心全意为您提供满分服务，欢迎您的来电!

The above is an introduction to Jinan Iron Art Gate. To learn more, please click: http://www.jnghbxg.com We will wholeheartedly provide you with full score service. Welcome to call us!