1.边框焊接  按边框尺寸在地上定位。将边框料的两端宽边上切成45。对接后点焊。校正无误<方框的对角线要相等)后焊牢。

1. The border welding is positioned on the ground according to the border size. Cut the two wide edges of the border material into 45 pieces. Spot welding after docking. After correction, ensure that the diagonals of the boxes are equal and weld them firmly.

2.中间长竖管焊接  每扇门3根长竖管，均匀分布在边框内，定位间距为339毫米。摆放好位置后，先点焊，再校平，检查无误后再焊牢。

2. Weld 3 long vertical pipes in the middle of each door, evenly distributed within the frame, with a positioning spacing of 339 millimeters. After placing the position, spot weld first, then level and check for accuracy before welding firmly.

3.矛头用横管焊接每扇门4根，夹在中问长竖竹之间、摆放好位置后，先点焊，再校平，检查无误后再焊牢:

3. Weld 4 horizontal pipes to each door with the spearhead, clamp them between the long vertical bamboo in the middle, place them in the right position, spot weld first, then level and check for accuracy before welding firmly:

4.中间短竖管焊接  侮扇门4根.按图样中的位置摆好。先点焊，再校平，检查无误后再焊牢。

4. Weld 4 short vertical pipes in the middle and place them according to the positions in the drawing. First spot weld, then level, check for accuracy, and then weld firmly.

5.短横管焊接每扇门24根.按图样中的位置摆好。先点焊，再校平，检查无误后再焊牢。为防l上焊接变形，可问隔焊。由于顺序打乱，焊点较多，焊完后应检查有无漏焊部位。

5. Weld 24 pieces of the shortest horizontal pipe for each door. Arrange them according to the position in the drawing. First spot weld, then level, check for accuracy, and then weld firmly. To prevent welding deformation, it is possible to ask for insulation welding. Due to the disorder of the order and the presence of many welding points, it is necessary to check for any missing areas after welding.

6.枪头焊接依次将各枪头分别焊在相应的位置上.要求与横杆垂直，正面朝前，不能扭曲。

6. Weld each gun head in the corresponding position in sequence. It is required to be perpendicular to the horizontal bar, facing forward, and not twisted.

7.花形焊接把所有花形分别摆放在相应位置上，看是否合适，调整无误后，先点焊到框架上，整体再检查一遍，然后焊牢。

7. Flower welding: Place all flower shapes in their respective positions, check if they are suitable, adjust them correctly, first spot weld them to the frame, check the whole again, and then weld them firmly.