1、边框焊接，按边框尺寸在地上定位。将边框料的两端宽边上切成45。对接后点焊。校正无误<方框的对角线要相等)后焊牢。

1. Weld the frame and position it on the ground according to the size of the frame. Cut the wide edges of both ends of the border material into 45 pieces. Spot welding after docking. Correctly correct (the diagonal of the box should be equal) and then weld it firmly.

2、中间长竖管焊接，每扇门3根长竖管，均匀分布在边框内，定位间距为339毫米。摆放好位置后，先点焊，再校平，检查无误后再焊牢。

2. The middle long vertical pipe is welded, with 3 long vertical pipes for each door evenly distributed within the frame, with a positioning spacing of 339 millimeters. After placing it in place, spot weld it first, then level it, check for accuracy, and then weld it firmly.

3、矛头用横管焊接每扇门4根，夹在中问长竖竹之间、摆放好位置后，先点焊，再校平，检查无误后再焊牢:

3. The spear head is welded with a horizontal pipe, with 4 pieces per door, sandwiched between the long and vertical bamboo in the middle, and placed in the correct position. After spot welding, leveling, and checking for accuracy, it is welded firmly:

4、中间短竖管焊接，侮扇门4根，按图样中的位置摆好。先点焊，再校平，检查无误后再焊牢。

4. Weld the short vertical pipe in the middle, and place 4 doors according to the position in the drawing. First spot weld, then level, check for accuracy, and then weld firmly.

5、短横管焊接每扇门24根，按图样中的位置摆好。先点焊，再校平，检查无误后再焊牢。为防l上焊接变形，可问隔焊。由于顺序打乱，焊点较多，焊完后应检查有无漏焊部位。

5. Weld 24 short horizontal pipes to each door and arrange them according to the position in the drawing. First spot weld, then level, check for accuracy, and then weld firmly. To prevent welding deformation on L, it is possible to ask for welding isolation. Due to the disordered sequence and a large number of welding points, it is necessary to check for any missed welding areas after welding.

6、枪头焊接依次将各枪头分别焊在相应的位置上，要求与横杆垂直，正面朝前，不能扭曲。

6. Weld the gun heads in their respective positions in sequence, ensuring they are perpendicular to the crossbar, facing forward, and not twisted.

7、花形焊接把所有花形分别摆放在相应位置上，看是否合适，调整无误后，先点焊到框架上，整体再检查一遍，然后焊牢。

7. Flower welding: Place all flower shapes in their respective positions to see if they are suitable. After adjusting them correctly, spot weld them onto the frame first, inspect the overall structure again, and then weld them firmly.